lumbar support adjustment. Pressing
and holding any of the direction
buttons for over two seconds will
stop the massage.
●
In massage mode, the up and
down buttons can be used to
switch massage patterns, and the
left and right buttons to adjust
the massage intensity. Switching
massage patterns does not alter
massage intensity.
●
Your last massage pattern and
intensity choices are remembered.
●
Press the up button to switch
between patterns in sequence of
"wave (default) → pulse → stretching
→ waist → shoulder → wave". Press
the down button to switch in the
reverse order.
●
The massage comes in three intensity
levels: Low, Medium (default) and
High. Press the left or right button to
switch to High or Low. These levels
do not circulate.
●
The massage mode automatically
ends 15 minutes after the last
adjustment. To continue, simply
press the seat massage button
or activate the massage via the
infotainment touchscreen.
5. Leg support adjustment
Pull the lever for the telescopic leg
support under the seat, move the
leg support longitudinally to a proper
position, and then release.
CAUTION
●
Releasing the switch stops the
seat in this position. Do not
place anything under the seat as
this may prevent the seat from
operating.
Memory System
Memory switch position
The memory system switch is located on
the trim of the driver's door. Two driving
positions can be recorded into memory.
Memory setting function
●
Memory setting conditions
●
The ignition has been switched on
and the vehicle speed is zero.
●
The driver's seat, side mirrors and
steering wheel have been adjusted to
the desired positions.
●
No operation is made on the driver's
seat, side mirrors and steering wheel.
●
Memory setting method
●
Press and release the "SET" button
on the seat memory switch, and
press either "1" or "2" within three
seconds. Then the positions of the
seat, side mirrors and steering wheel
will be recorded with a beep, and the
memory setting nishes.
64
To Next Page
Loading...
