Set the light switch to . The BCM
captures the brightness data from the
light intensity sensor to automatically
turn the position lights and low beam on
or o.
REMINDER
●
The light intensity sensor is
located on the top of the
windshield. Do not block the
sensor or let anything splash on it.
Position lights
Set the light switch to to turn on
position lights and license plate light.
Low beam
Set the light switch to to turn on the
low beam.
Rear fog lights
Set the light switch to and rotate the
fog light dial to to turn on rear fog
lights.
High beam
Set the light switch to and push the
light switch lever down (away from the
steering wheel) to turn on the high beam.
Overtaking light
Pull up the lever (toward the steering
wheel) to turn on the overtaking light.
Release the lever for the light switch to
75
03
CONTROLLER OPERATION
To Next Page
Loading...
