BYD TANG 2024 - E-Call Switch

WARNING
●
If the switch is OFF, the passenger
airbag is still enabled, contact
a BYD authorized dealer or
service provider immediately for
maintenance.
CAUTION
●
To prevent damage to the airbag
system, only operate the PAB
switch when the ignition is OFF.
●
It is the driver's responsibility to
con󽗉rm that the PAB switch is
in the correct position for the
passenger sitting in the front
passenger seat.
E-Call Switch
① E-Call status indicator
② SOS button
●
E-Call refers to emergency call. To
trigger the E-Call, press the SOS button
for two seconds or longer and less
than 30 seconds, and do not press it
a second time within eight seconds.
●
To cancel an emergency call made
by mistake, press the SOS button a
second time within eight seconds.
●
The E-Call system activates
automatically in the event of airbag
deployment or the detection of a
severe collision.
●
When triggered, the system
automatically makes an emergency
call and communicates standard
information to a public safety
answering point.
CAUTION
●
The E-Call system restarts when
the SOS button is pressed for 30
seconds or longer and less than
one minute.
●
The SOS button will be considered
to be short-circuited (button
stuck) if you press and hold the
SOS button for one minute or
longer. In that case, the E-Call
cannot be triggered manually.
●
The dialed emergency call cannot
be manually canceled from the
vehicle until the PSAP hangs up or
no one answers the call after it is
dialed over 20 consecutive times.
The E-Call system then enters a
60-minute wait for a callback.
●
Provision of TPS E-Call service
is dependent on the technology,
laws and regulations of speci󽗉c
countries. Where TPS E-Call
limitations exist, the system will
default to standard E-Call.
Status LED Indicator
Ignition o󽗈 or E-Call system failure O󽗈
Power-on self-check mode Flashing fast - 2 Hz
83
03
CONTROLLER OPERATION