Closing the sunshade
●
Press and hold the sunshade close
button ② to close the sunshade.
Release the button midway to stop the
sunshade at its current position.
●
If the sunshade has been initialized,
releasing the button ② immediately
after touching it closes the sunshade
automatically. For the sunshade to
stop at its current position, press
button ① or ② midway.
REMINDER
●
When the sunroof is not fully
closed, the sunshade position will
never be further than that of the
sunroof.
Sunshade linkage function
●
When the sunroof is opened, the
sunshade will be opened together with
the sunroof.
Anti-pinch Function
If the sunroof or sunshade closing process
is obstructed by anything, it will stop and
slightly retract.
WARNING
●
Keep clear of the sunroof when
it is opening or closing. Serious
injury may occur when passengers
WARNING
have their body parts caught in
the sunroof.
●
Passengers must refrain from
sticking hands or their heads
out through the sunroof during
driving. Failure to do so may result
in serious injury or death.
CAUTION
●
Water may enter the cabin when
operating the sunroof after rainy
or snowy weather or after washing
the vehicle. Wipe it clean with a
dry cloth before operating.
●
Trying to open the sunroof in
outside temperatures below 0℃
or when it is covered in snow or
frost may damage the sunroof or
its motor.
REMINDER
●
The sunshade opens
automatically when the sunroof
is opening. When the sunroof
pauses, the sunshade will then
pause.
Initialization
With the ignition on, the signal remains
valid and the sunroof is in the
uninitialized state, try the following steps
for initialization:
1. Press and hold the sunroof closing
switch to make the sunroof move to
the fully closed position and stall for
0.4 seconds. The sunroof initialization
is then complete.
2. After the sunroof has been initialized
and is fully closed, press and hold
the sunshade closing switch to make
85
03
CONTROLLER OPERATION
To Next Page
Loading...
