the instrument stays on after flashing and the message "EPB activated" is
displayed.
■ Applying the EPB automatically when gearshift lever is in P position:
● When the vehicle speed is less than 3 km/h, the gearshift lever is in D or R position
and the door is being closed, the gearshift will shift to P position and the EPB will be
applied automatically.
Releasing the EPB automatically when the vehicle is starting to move
■ Releasing the EPB automatically upon shifting gear:
● With the vehicle parked on a flat road, start the vehicle, depress and hold the brake
pedal, and shift to D position or R position from P position or N position, and then
the EPB will be released automatically, the indicator will go out, and the
instrument will display the message of "EPB deactivated".
■ Releasing the EPB automatically upon depressing accelerator pedal:
● When the vehicle has been started, the gearshift lever is in D or R position and the
EPB is pulled up, depress the accelerator pedal slowly to a certain depth, and then
the EPB will be released automatically, the indicator will go out, and the
instrument will display the message of "EPB deactivated".
With the AVH button pressed, the automatic
vehicle hold function will be activated when
the operating conditions for AVH are
satisfied.
This function is designed to avoid adverse consequences caused by a driver leaving the
vehicle after powering it off without applying parking brake, and to improve the vehicle
safety. Excessive reliance on or frequent use of the function is not recommended.
To Next Page
Loading...
