Need help?Do you have a question about the Caberg AVALON and is the answer not in the manual?
General| Type | Full-face helmet |
|---|---|
| Certification | ECE 22.05 |
| Retention System | Micrometric buckle |
| Ventilation | Adjustable chin vent and top vents |
| Interior | Removable and washable |
| Sun Visor | Integrated sun visor |
| Weight | 1500 +/- 50g |
| Visor | Pinlock ready |
Open visor to near-final snap, push lever A to release, repeat on other side.
Place central pivot and hook B into mechanism, push hook C to clip under release.
Drive sunshade visor lever downwards and pull smoked visor slightly outward.
Drive sunshade visor lever downwards, insert visor parts, and press lightly to seat.
Pull cheek pads inward, detach rear studs, and repeat on the opposite side.
Remove neck device lining by pulling slightly inward to release rear fixing frame.
Remove front fixing plastic frame by pulling inward.
Remove the entire lining completely.
Place the main liner padding inside the helmet.
Place front plastic frame and fix it to the seat on the EPS liner.
Place rear plastic frame and fix it to the seat on the EPS liner.
Adjust cheek pads by placing fixing strip between shell and EPS, then hook buttons.
Remove the clear visor as indicated in the instructions.
Flex visor, place lens between pins, ensuring silicon seal contacts visor.
Remove the protective film from the antifog lens.
Fit the helmet visor back onto the helmet.
Remove the clear visor as indicated in the instructions.
Flex visor carefully until tension is gone, then remove lens from its position.
To Next Page
