To Next PageTo Next Page
Need help?Do you have a question about the Cablexpert NCT-3 and is the answer not in the manual?
Lists the main capabilities and functions of the cable tester.
Details the device's operational parameters and requirements.
Step-by-step instructions for inserting batteries into the tester.
Illustrates the correct connection of the main unit and remote tester.
Explains the available settings in the setup menu, like unit and calibration.
Procedure to select the preferred measurement unit (Meter or Feet).
Detailed steps for calibrating the tester for accurate length measurements.
How to fine-tune the device's calibration for precise length readings.
Procedure for testing and responding to cables detected as too short.
How the tester indicates a short circuit between wires.
Explains the 'PASS' result for a correctly mapped cable.
Details error messages for missing adapters or short circuits.
Explains the 'FAIL' result and potential causes for wire mapping issues.
Displays the measured lengths for each individual wire pair.
Shows the measured lengths for specific pins within the cable.
Displays the outcome of testing coaxial or telephone cables (e.g., PASS).
Indicates when an open circuit is detected in coaxial or telephone cables.
Visual guidance on safe handling and potential environmental impacts.
Outlines the requirements and scope of the product's warranty.
General| Cable type | STP/UTP |
|---|---|
| Display type | LCD |
| Product color | Gray |
| Supported connectors | RJ-45 |
| Measuring cable length | Yes |
| Operating temperature (T-T) | -10 - 60 °C |
| Battery type | AA |
| Battery voltage | 1.5 V |
| Operating voltage | 6 V |
| Number of batteries supported | 4 |
| Master (outer) case weight | 9400 g |
| Quantity per master (outer) case | 20 pc(s) |
Weight and Dimensions| Weight | 250 g |
|---|---|
| Package width | 250 mm |
| Package height | 145 mm |
| Package length | 60 mm |
| Dimensions (WxDxH) | 180 x 80 x 40 mm |
