Universal Transmitter (Option)
This transmitter allows you to consolidate the functions
of up to three individual hand-held transmitters. It will
operate garage doors and gates, or with the accessory
package, other devices controlled by radio frequency
such as home/office lighting systems.
The transmitter will learn and transmit the frequencies
of most current transmitters and is powered by your
vehicle’s battery and charging system.
This
device complies with
Part
15
of the
FCC
Rules.
Operation is subject to the following two conditions:
(1)
this device may not cause harmful interference, and
(2)
this
device must accept any interference received,
including interference that may cause undesired operation.
This
device complies with
RSS-210
of Industry and Science
Canada. Operation is subject to the following
two
conditions:
(1)
this
device may not cause interference, and
(2)
this
device
must accept any interference, including interference that may
cause undesired operation of the device.
Programming the Transmitter
Do not
use
the universal transmitter with any garage
door opener that does not have the “stop and reverse”
safety feature. This includes any garage door opener
model manufactured before April
1,
1982.
Be sure that people and objects are clear
of
the garage
door you are programming.
Your vehicle’s engine should be turned
off
while
programming the transmitter. Follow these steps to
program up to three channels:
1.
If
you have previously programmed a transmitter
channel, proceed to Step
2.
Otherwise, hold down
the two outside buttons on the universal transmitter
until the red light begins to flash rapidly
(approximately
20
seconds). Then release the
buttons. This procedure initializes the memory and
erases any previous settings for all three channels.
2.
Decide which one of the three channels you want
to program.
2-65
To Next Page
Loading...
