\
ENGMET:
You
can
change the display
from
English
(miles) to metric (kilometers) by pressing
this
button.
The
same button also changes other readings (like
temperature, fuel and odometer).
TRIP
SET
By using this button, you can tell how far
you’ve gone since you last set the
TRIP
SET
back to
zero.
To
reset, press and hold the button until zeros
appear. If your vehicle is domestic, the trip odometer
will return to zero after
999.9
miles
(1
609
km).
If
your vehicle is Canadian, the trip odometer will return
to zero after
1
999.9
km
(1,242
miles).
INFORMATION:
Pressing this button repeatedly will
display the MPG
AVG,
MPG
INST, GAL FUEL
USED,
AVG
MPH,
ENGINE
RPM,
BATTERY VOLTS,
COOLANT
TEMP
and
OIL
LIFE
LEFT.
TIMER:
This
feature
is
like a stopwatch, in that
you can clc
c
the time it takes to get from one point
to another.
To
operate, press the
TIMER
button until
TIMER
OFF
0O:OO:OO
is displayed on the
DIC.
Each of the fields for
the hours, minutes and seconds are two numeric digits.
Once
TIMER
OFF
0O:OO:OO
is displayed, press the
TIMER
button to start the timing feature. Press the
TIMER
button again to stop it.
If
you will be starting
and stopping your Cadillac, during
a
trip for instance,
the
TIMER
feature will automatically start timing where
it left
off
when you last stopped.
To
reset it, press and
hold the
RESET
button until the display reads
TIMER
0O:OO:OO.
Press the
INFORMATION
button to exit from
the
TIMER
function.
RESET:
Pressing this button will reset the MPG
AVG,
MPG INST, GAL
FUEL
USED,
AVG
MPH and
OIL
LIFE LEFT. Pressing
RESET
when a non-resettable
display appears will cause a “recall” mode to occur.
When this happens, all
DIC
warning messages that have
been displayed since the ignition key was turned to
RUN
will redisplay.
If
no messages were displayed, a
MONITORED
SYSTEMS
OK
message will appear.
2-86
To Next Page
Loading...
