2.
Push it back in all the way, wait three seconds and
then pull it back out ‘again.
3.
Check both sides
of
the dipstick, and read the
lower level. The fluid level must be in the
cross-hatched area.
4.
If
the fluid level is in the acceptable range, push
the dipstick back in
all
the way. Replace the
air
cleaner assembly.
How
to
Add
Fluid
Refer to the Maintenance Schedule to determine
what kind of transaxle fluid to use. See
“Recommended Fluids and Lubricants” in
the Maintenance Schedule booklet.
If
the fluid level is low, add only enough
of
the proper
fluid to bring the level into the cross-hatched area on
the dipstick.
1.
Pull
out the dipstick.
2.
Using a long-neck funnel, add enough fluid at the
dipstick hole to bring it
to
the proper level.
It doesn’t take much fluid, generally less than
one pint
(0.5
L).
Don’t
oveflll.
NOTICE:
We recommend you use only fluid labeled
DEXRON@-111, because fluid with that label .is
made especially for your automatic transaxle.
Damage caused by fluid other than DEXRON-In
is not covered by your new vehicle warranty.
3.
After adding fluid, recheck the fluid level as
4.
When the correct fluid level is obtained, push the
described under “How to Check.”
dipstick back in all the way.
6-20
To Next Page
Loading...
