The RKE transmitter can also be used to recall the
memory settings for up to two drivers. For more
information, see “Memory Seat and Mirrors” in
the Index.
Note that pressing the transmitter buttons numerous times
(approximately
500
times) out of the vehicle’s operating
range may cause the transmitter not to work. Replacing
the battery and pressing the transmitter buttons
10
or
more times out of range will also cause
the
transmitter
not to work. To reset the transmitter, you must be within
the vehicle’s operating range. Press and hold the trunk
button, and within one second, press and hold the lock
button. Continue to hold both buttons for approximately
three seconds. See your Cadillac dealer for service if your
transmitter still doesn’t work properly.
RKE
Personalization Features
Remote Confiimation
(If
Equipped)
Before you select features, be sure that the number on
the back of the RKE transmitter matches the driver
preferred.
You
can confirm the correct driver by placing
the key in the LOCK position and pressing unlock on
the
RKE
transmitter.
This
personalization feature allows the driver to program
the parking lamps to blink or to remain
off
when the lock
or unlock buttons
on
the
RKE
transmitter are pressed.
Press the TRIP SET
(TRIP
RESET) button to answer
“yes,” press
the
RESET
(INFO
RESET) button to indicate
“no” or press the INFORMATION
(INFO)
button to
“skip” to the next personalization feature.
To
begin programming, the ignition must be in the RUN
position. Press and hold the INFORMATION (INFO)
and RESET (INFO RESET) buttons at the same time.
The first message to appear refers to the programmable
automatic door locks. To skip this prompt, press the
INFORMATION (INFO) button.
When
REMOTE
FLASH LIGHTS appears on the DIC
display, press the yes button
to
program the parking
lamps to blink once when the lock button on the
RKE
transmitter is pressed and to blink twice when the
unlock button is pressed.
If
you don’t want the parking
lamps to blink when using the
RKE
transmitter, press
the
no
button.
FEATURE
ON
will display if REMOTE
FLASH
LIGHTS was selected and FEATURE
OFF
will show if
you answer no.
For
a
list of the other personalization features available,
see “Memory and Personalization Features” later in
this section.
To Next Page
Loading...
