Do
not
use
the universal transmitter with any garage
door opener that does not have the “stop and reverse”
safety feature.
This
includes
any
garage door opener
model manufactured before April
1,
1982.
Be sure that people and objects are clear
of
the garage
door you are programming.
Your vehicle’s engine should be turned
off
while
programming the transmitter. Follow these steps to
program up to three channels:
1.
If
you have previously programmed a transmitter
channel, proceed
to
Step
2.
Otherwise, hold down the
two
outside buttons on the universal transmitter until
the red light begins to flash rapidly (approximately
20
seconds). Then release the buttons.
This
procedure
initializes
the
memory and erases
any
previous
settings for all three channels.
2.
Decide which
one
of
the three channels you want
to
program.
3.
4.
5.
Hold the end of the hand-held transmitter against the
front surface of
the
universal transmitter
so
that
you
can
still see the red Light.
Using both hands, press the hand-held transmitter
button and
the
desired button on the universal
transmitter. Continue to press both buttons through
Step
5.
Hold down both buttons until you see the red light
on the universal transmitter flash slowly and then
rapidly. The rapid flashing, which could take up to
90
seconds, indicates that the universal transmitter
has been programmed. Release both buttons once
the light starts to
flash
rapidly.
If
you have trouble programming the universal
transmitter, make sure that you have followed the
directions exactly
as
described and that the battery
in
the
hand-held transmitter is not dead. If you still cannot
program
it, rotate
the
hand-held transmitter end
over
end
and
try
again. The universal transmitter may not work
with older garage door openers that
do
not meet current
Federal Consumer Safety Standards. If
you
cannot
program the transmitter after repeated attempts, consult
YOU
Cadillac dealer.
2-
To Next Page
Loading...
