DEFROST:
Press this button to quickly remove
fog
or
frost from the windshield. This setting sends most
of
the airflow to the windshield with only a small
amount to the floor outlets.
88
FAN
SPEEDS:
Press the button with the fan symbol
on it until
AUTO
is displayed on the screen. At
this
setting, the
fan
speed is automatically controlled.
If
it is
cold outside, the blower may
not
run in the maximum
hgh
fan
speed right away. The system checks the
temperature
of
the engine coolant to assure it is warm
enough to provide heat.
When
the engine coolant is
warm, the controller allows the
fan
to gradually increase
to a higher speed.
This
prevents cold
air
from blowing
into the passenger compartment.
If
you want the blower
fan
at a high speed, press
the
up arrow button until you
see
HI
on
the
display. If you want the
fan
speed to be
automatic, but you like the
fan
speed to be higher than
the
AUTO
setting,
press
the fan symbol button until
HI
AUTO
is shown on the display.
If
you
want
the blower
fan at a low speed, press the down
arrow
button until
LO
is shown on the display.
If
you want the fan speed to run
lower
than
the
AUTO
setting, press the button until
LO
AUTO
is shown on
the
display.
OFF:
Press this button to
turn
the system
off.
Fresh air
will continue to flow through the vehicle, and the
system will try to maintain the previously set
temperature. The outside temperature will show on the
display when the system
is
OFF.
AC:
Press this button to
turn
the air conditioning on and
off.
The system will cool and dehumidify the
air
inside
the
vehicle.
In
the AUTO mode, the display will show
that
AC
is
active, but the air conditioning compressor
only operates when the system determines
it
is needed.
RECIRCULATION:
Press this button to limit the
amount of fresh
air
entering your vehicle. This is helpful
when you are trying to cool the air quickly or limit odors
entering your vehcle. In the
AUTO
mode, the system
will use recirculation as necessary to cool the air.
Pressing the recirculation button will change the
operation to a manual mode and the air will recirculate
non-stop. Press
this
button again to
turn
off
the
recirculation feature.
If you notice the windows fogging, press the
recirculation button to exit the recirculation mode.
To Next Page
Loading...
