Some cleaning cassettes
or
CD
adapter
kits
may appear
as
a
broken tape.
If
the cleaning cassette
is
ejected
immediately from the tape player, follow these steps
for
the
TAPE
CLEAN
OVE
E.
Turn the ignition
to
RUN
or
ACC.
2.
Turn the radio
off.
3.
Press and hold the
SOURCE
button for three
seconds. After thee seconds, the tape icon will flash
indicating the cut tape feature
is
now turned off.
4.
Turn
the
radio on
and
insert the cleaning cassette
(CX
the
CD
adapter
kit).
5.
Eject
the
tape
after
the
tape player has been cleaned.
When
the
cleaning cassette has been ejected,
the
broken
tape detection feature
is
active
again.
YOU
may also choose
a
non-scrubbing action, wet-type
cleaner which uses a cassette with
a
fabric belt to clean
the
tape
head. This type
of
cleaning cassette will not
eject and, it may
not
clean as thoroughly as the
scrubbing
type
cleaner.
Cassettes are subject to
wear
and
the
sound quality
may degrade over time. Always make sure the cassette
tape
is
in
good condition.
before
YOU
have your tape
player serviced.
Handle discs carefully. Store them in their original case:
or other protective cases
and
away from direct sunlight
and dust. If the surface
of
a
disc is soiled, dampen
a
clean,
soft
cloth
in
a mild, neutral detergent solution
anc
clean
it,
wiping from
the
center
to
the edge.
Be
sure
never to touch the signal surface when handling
discs. Pick up discs by grasping the outer edges or the
edge
of
the hole and the outer edge.
Your power antenna will look its best and work
well if it’s cleaned
from
time to time.
To
clean the
antenna mast:
1.
Turn
on
the
ignition and radio to raise the antenna.
2.
Dampen a clean cloth with mineral
spirits
or
equivalent solvent.
3.
Wipe the cloth over
the
mast sections, removing
any dirt.
3-27
To Next Page
Loading...
