4.
With the coolant surge tank pressure cap
off,
start the
engine and let
it
run
until
you
can feel the upper
radiator hose getting hot. Watch out
for
the
engine fans.
By
this
time,
the
coolant level inside the coolant
surge tank
may
be
lower.
If
the
level is lower,
add
more
of
the
proper mix to the
coolant
surge
tank
until
the
level reaches about
2.5
inches
(6.4
cm)
below
the
base
of
the filler neck.
5.
Then replace the pressure cap.
Be
sure
the
~QWS
on
Start the engine and allow
it
to
warm
up.
If
the
CHECK
COOLANT LEVEL
message does not appear on
the
Driver Infomation Center, coolant is at
the
proper
fill
level.
If
a
CHECK
COOLANT
LEVEL
message
does
appear, repeat Steps
1
through
3
or
see your dealer.
the
pressure cap line
up
like
this.
-2
To Next Page
Loading...
