3.
Check both sides of the dipstick, and read the lower
level.
”he
fluid level must be
in
the cross-hatched area.
4.
If
the fluid level
is
in the acceptable range, push
the dipstick back in
a11
the way. Replace the air
cleaner assembly.
Refer
to
the
Maintenance Schedule
to
determine what kind
of
transaxle
fluid
to use. See “Recommended Fluids
and
Lubricants” in
the
Maintenance Schedule booklet.
If’
the fluid level
is
low, add
only
enough
of
the proper fluid
to
bring
the level into
the
cross-hatched area
on
the dipstick.
1.
Pull
OW
the dipstick.
2.
Using
a
long-neck funnel, add enough fluid
at
the
dipstick hole to bring
it
to the proper level.
It doesn’t take
much
fluid, generally less than one pint
(0.5
L).
Don’t
oveflll.
3.
After adding fluid, recheck
the
fluid level
as
described under
“How
to
Check.”
4.
When
the correct fluid level is obtained,
push
the
dipstick back
in
all
the
way.
To Next Page