A
“yes” or “no” response
must
be made after each
prompt is displayed
in
order to continue on to the next
prompt or personalization feature. Press the TRIP
SET
(TRIP
RESET)
button to choose yes, press
the
RESET
(INFO
RESET) button to choose no or press the
INFORMATION
(INFO)
button to “skip” to the
next
personalization feature.
FEATURE
ON
appears when a
yes
response
is
made
and FEATURE
OFF
appears with a
no
response.
If
a
no response
is
made after the
DOQRS
LOCK
IN
GEAR
prompt
is
displayed,
FEATURE OFF
will appear.
The automatic door locking system has been disabled
and
no
other door
lock
messages will be displayed.
REMOTE
FLASH
LIGHTS,
which is the next available
personalization
feature
to
display, will
appear
next.
See “Remote Confirmation”
in
the Index for
more information.
If
a yes response is made
after
the
DQORS
LOCK
IN
GEAR prompt
is
displayed,
%;EA’
ON
appears.
The automatic door locking system is enabled and allows
the
DOORS
UNLOCK
IN
PARK prompt to zppear.
Choosing
this prompt advances you to
REMOTE
FLASH
LIGHTS
whereas
a
no
response will display the
DRIVR
UJYLOCK
IN
PARK
prompt.
A
yes
or
no response
here automatically brings up the
REMOTE
FLASH
LIGHTS feature.
Leaving your key in any igmtion position
with
either door
open will disable
the
use
of
the
power door lock switches.
The
anti-lockout feature
is
disabled when the ignition is
on.
If
you close the doors, you can lock them using the
RKE system. It is always recommended that you remove
your ignition
key
when lockmg your vehicle.
Note that the anti-lockout feature can be overridden by
holding the power door
lock
switch
for
three seconds
or
longer.
If
you
are leaving the vehicle, open the door, set the
locks from the inside, get out and close
the
door.
To Next Page
Loading...
