2-71
Sunroof (Option)
The two control switches to operate the sunroof are
located on the overhead console and include VENT,
ROOF, open and close.
The control switches work only when the ignition is
on or the Retained Accessory Power (RAP) is active.
See “Retained Accessory Power” in the Index.
To open the glass panel and sunshade, press and
hold the ROOF switch rearward to the first position.
The sunshade can also be opened by hand. To close the
glass panel, press and hold the ROOF switch forward.
As the glass panel closes, it will open slightly toward the
vent to provide a better seal. The sunshade can only be
closed by hand.
To express
-open the glass panel to a partially open
position, press and release the ROOF switch rearward
to the second position. The glass panel may be fully
opened by pressing the ROOF switch again.
To stop the glass panel when express opening, press
either the ROOF or VENT switch in any direction.
If you press and hold the ROOF switch in the express
open position for more than one second, the express
open operation will be over
-ridden and the sunroof will
stop when the switch is released.
To vent the glass panel, press and hold the VENT switch
in the open position. The sunshade must be opened by
hand. To close the glass panel, press and hold the VENT
switch in the close position.
To Next Page
Loading...
Need help?
General
