1-3
Massaging Lumbar (If Equipped)
Push the top of the lumbar
control located on the
outboard side of the seat
where it is marked AUTO
briefly to activate the
massage feature.
The massage cycle will run continuously for up to
10 minutes and can be interrupted by pushing the
lumbar control down briefly. The lumbar support can
be adjusted during the massage cycle by moving the
switch forward to increase support and rearward to
decrease support. The massage cycle will continue
to run even if the ignition is turned to OFF,
unless interrupted.
Four-Way Rear Power Lumbar
(If Equipped)
Four-way lumbar, without
the massage feature, is also
available for the outboard
rear seating positions.
To activate the rear lumbar feature, push forward on the
switch located on the rear door trim to increase support
or rearward to decrease support. The lumbar switch can
also be moved up and down to adjust the location of
the support.
To Next Page
Loading...
