1-5
Memory Seat, Mirrors and Steering
Wheel (Option)
The controls for these
features are located on the
driver’s door panel, and are
used to program and recall
memory settings for the
driver’s seating positions.
Adjust the driver’s seat (including the seatback recliner,
lumbar and shoulder belt height adjustments), both the
outside mirrors and steering wheel to a comfortable
position and then press the MEMORY SET button.
Within five seconds, press button “1” (for driver 1).
A second mirror, seating and steering wheel position
can be programmed by repeating the above steps and
pressing button “2” (for driver 2). Each time a memory
button is pressed, a single beep will sound. Each time
button 1 or 2 is pressed and released while the vehicle
is in PARK (P), the memory positions will be recalled.
Each time button 1 or 2 is pressed and held while the
vehicle is out of PARK (P), the memory positions will
be recalled.
To stop recall movement of the memory seat and
steering wheel at any time, press one of the power seat,
steering wheel or mirror controls.
Two personalized exit positions can be set by first
recalling the driving position (by pressing 1 or 2),
then positioning the steering wheel and seat in the
desired exit positions and then pressing and releasing
the MEMORY SET button and, within five seconds,
pressing the EXIT button. With the vehicle in PARK (P),
the exit position for either previously set driver can be
recalled by pressing the EXIT button. The mirrors,
power lumbar and shoulder belt height positions will
not be stored or recalled for the exit positions.
To Next Page
Loading...
Need help?
General
