2-29
DRIVE (D): This position is for normal driving. If you
need more power for passing, and you’re:
D
Going less than 35 mph (55 km/h), push the
accelerator pedal about halfway down.
D
Going about 35 mph (55 km/h) or more, push the
accelerator all the way down.
The transaxle will shift down to the next gear and
have more power.
NOTICE:
If your vehicle seems to start up rather slowly, or
if it doesn’t seem to shift gears as you accelerate,
something may be wrong with a transaxle system
sensor. If you drive very far that way, your
vehicle can be damaged. So if this happens, have
your vehicle serviced right away. Until then, you
can use SECOND (2) when you are driving less
than 35 mph (55 km/h) and DRIVE (D) for
higher speeds.
THIRD (3): This position is also used for normal
driving, however, it offers more power and lower fuel
economy than DRIVE (D).
Here are examples for using THIRD (3) instead
of DRIVE (D).
D
When driving on hilly, winding roads.
D
When towing a trailer, so there is less shifting
between gears.
D
When going down a steep hill.
SECOND (2): This position gives you more power.
You can use SECOND (2) on hills. It can help control
your speed as you go down steep mountain roads, but
then you would also want to use your brakes off and on.
NOTICE:
Don’t shift into SECOND (2) unless you are
going slower than 65 mph (105 km/h), or you
can damage your engine.
To Next Page
Loading...
Need help?
General
