2-92
Before your vehicle was shipped from the factory, it was
programmed to enable Mode 1. The mode to which the
vehicle was programmed may have been changed since
it left the factory. To determine the mode to which the
vehicle is programmed or to program the vehicle to a
different mode, do the following:
1. Enter feature programming following the
instructions listed previously.
2. Press the SKIP INFO button until REMOTE
RECALL MEMORY appears on the display.
3. Press YES TRIP RESET to select this feature
for programming.
4. A yes or no response must be made after each mode
is displayed in order to continue to the next mode.
Press the YES TRIP RESET button to indicate yes
to turn this feature on, or press NO INFO RESET to
turn this feature off.
FEATURE ON is displayed after a yes response.
If you respond with no, FEATURE OFF is briefly
displayed. Then, KEY IN RECALL MEMORY
will appear on the display, and you will be able to
program this feature.
MIRROR TILT IN REV will appear on the display
once a mode has been selected for the remote recall
memory feature.
If you press the SKIP INFO button, the menu will
advance to the next feature available for programming.
The mode you selected is now set. You can either exit
the programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.
To Next Page
Loading...
