3-6
To avoid blowing cold air in cold weather, the system
will delay turning on the fan until warm air is available.
The length of delay depends on the outside air
temperature, engine coolant temperature or the
time since the engine was last started. As the coolant
warms up, the fan speed will gradually increase and
air will flow from the floor outlets, with some airflow
to the windshield to prevent fogging under most
normal conditions.
If you leave your vehicle, the system will remember
the control setting the next time you start your engine,
except for recirculation and defrost. Each ignition cycle
cancels recirculation, whereas, defrost mode will change
to automatic operation when the ignition is shut off and
then turned back on.
Electronic Solar Sensor
The sensor monitors the sun’s solar radiation and
is located on top of the instrument panel near the
windshield. The electronic climate control panel uses
this information to automatically make the necessary
temperature and airflow adjustments to maintain
your comfort.
To Next Page
Loading...
