Reprogramming a Single HomeLink@
Button
To
program a device
to
HomeLink@ using a HomeLink@
button previously trained, follow these steps:
1.
Press and
hold
the desired HomeLink@ button.
Do
not release the button.
2.
The indicator light will begin
to
flash after
20
seconds. While still holding the HomeLink@
button, proceed with Step
2
under “Programming
HomeLink@.”
Resetting Defaults
To
reset HomeLink@
to
default settings do the following:
1.
Hold
down the two outside buttons for about
20
seconds until the indicator light begins
to
flash.
2.
Continue
to
hold both buttons until the HomeLink@
indicator light turns
off.
3.
Release both buttons.
For questions or comments, contact HomeLinkO at
1-800-355-3515,
or on the internet at
www. homelink.com.
2-40
To Next Page
Loading...
