If
the URPA
Display
Flashes Red
If
the URPA system is not functioning properly, the
display will flash red, indicating that there is a problem.
The light will also flash red while driving
if
any of the
following conditions exist:
A
trailer or trailer-hitch ball mount is attached
to
your vehicle.
the cargo area.
speed greater than
3
mph
(5
km/h).
A bicycle or object is on the back of, or hanging out
If your vehicle is moving in
REVERSE
(R)
at a
The light will continue
to
flash until the trailer or the
object is removed and your vehicle is driven forward at
least
15
mph
(25
km/h).
It
may also flash red
if
the ultrasonic sensors are not
kept clean.
So
be sure
to
keep your rear bumper free of mud, dirt,
snow, ice and slush or materials such as paint or
the system may not work properly. If after cleaning the
rear bumper and driving forward at least
15
mph
(25
km/h), the display continues
to
flash red, see your
dealer. For cleaning instructions, see Cleaning the
Outside
of
Your
Vehicle on page
5-93.
Other conditions that may affect system performance
include things like the vibrations from a jackhammer or
the compression of air brakes on a very large truck.
As always, drivers should use care when backing up a
vehicle. Always look behind you, being sure
to
check
for other vehicles, obstructions and blind spots.
Accessory Power Outlets
With accessory power outlets you can plug in auxiliary
electrical equipment such as a cellular telephone or
CB
radio.
Your vehicle is equipped with many accessory power
outlets.
One outlet
is
located in the center console. Press the
button on the side of the console door
to
access
the outlet.
There may also be accessory power outlets located on
the back of the center console above the cupholder
and in the rear cargo area on the passenger side.
Do
not
try
to
put the cigarette lighter in any of the
accessory outlets.
3-20
To Next Page
Loading...
