2
(Panel):
This setting will deliver air
to
the
instrument panel outlets.
+2
(Bi-Level):
This setting will deliver warmer air
to
the
floor
and cooler air
to
the instrument panel outlets.
tg
(Floor):
This setting will deliver air
to
the floor
outlets.
+3
(Defog):
See “Defogging and Defrosting” later in
this section.
&
(Recirculation):
Press this button
to
limit the
amount of outside air entering your vehicle. The light on
the recirculation button will glow. This is helpful when you
are trying
to
limit odors entering your vehicle and for
maximum air conditioning performance in hot weather.
Press this button again
to
allow outside air
to
enter the
vehicle. The light on the recirculation button will go
off.
Pressing this button cancels the auto recirculation
feature. To resume the auto recirculation function, press
the AUTO button. Each time the vehicle is started, the
system will revert
to
the auto recirculation function.
If you select recirculation while in defrost, defog or floor,
the light on the button will flash and go out
to
let you know
this is not allowed. This is
to
prevent fogging.
When the weather is cool or damp, operating the system
in recirculation for extended periods of time may cause
fogging of the vehicle’s windows. To clear the fog, select
either defog or front defrost. Be sure
A/C
off
is not
selected. You will want
to
allow the air conditioning
to
run
automatically
to
help dehumidify the air.
Display
If you press the MODE button
to
select an air delivery
mode, the display will change
to
show you the selected
air delivery mode. After ten seconds, the display will
change
to
show the driver temperature setting and the
selected mode.
If you press the up or down arrows on the fan switch,
the display will change
to
show the selected fan speed.
After ten seconds, the display will change
to
show
the driver temperature setting and the selected mode.
Whenever you press AUTO, the display will change
to
show the following:
0
the current driver’s set temperature and an arrow
the current passenger’s set temperature setting and
the automatic air delivery mode and fan speed.
for five seconds,
an arrow for five seconds and
If the driver’s and passenger’s temperature settings are
the same when AUTO is pressed, the temperature
setting and both arrows will be displayed for five
seconds along with the automatic air delivery mode and
fan speed. After the five second update, the display
will change
to
show the temperature setting, both arrows
and AUTO.
3-25
To Next Page
Loading...
