Once the seatbacks are folded down, on Escalade ESV
models only, the rear seat footwell area will be
exposed and will have
to
be covered by the load floor
panel.
To create a load floor, do the following:
Returning the Seatbacks to an Upright
Position
1.
Release the panels from the seatbacks by pushing
forward on the latches.
2.
Then fold the panels back
to
cover the rear seat
footwell area.
If
the seatback isn’t locked, it could move
forward
in
a sudden stop or crash. That could
cause injury to the person sitting there. Always
press rearward on the seatback
to
be sure
it
is
locked.
To
return the seatbacks
to
the upright position, do the
following:
1.
2.
3.
4.
5.
On Escalade ESV models, lift the load floor panels
and latch them into the seatback.
Lift
the seatback up and push
it
rearward all the
way. On Escalade ESV models, move the headrest
to
the seatback.
Lower the seat cushion until it latches into position.
Pull forward on the seatback and up on the seat
cushion
to
make sure the seat is securely in
place.
On Escalade models, return the headrests
to the
upright position.
1-24
To Next Page
Loading...
