1.
Remove the headlamp assembly as described
previously.
2.
Remove the rubber, circular-shaped bulb cap for
the affected bulb from the headlamp assembly.
3.
Press the locking release lever, turn the bulb socket
counterclockwise and remove it from the headlamp
assembly. (There is no lock for the sidemarker
lamp.)
4.
Remove the old bulb from the bulb socket.
5. Put the new bulb into the bulb socket.
6. Put the bulb socket into the turn signal housing and
turn it clockwise until it locks. (There is no lock for
the sidemarker lamp.)
7.
Reinstall the rubber, circular-shaped bulb cap to the
8.
Put the headlamp assembly back into the vehicle
headlamp assembly.
by reversing the previous mentioned steps.
Center High-Mounted Stoplamp
(CHMSL)
It
is
recommended that this component be replaced as
a unit.
Taillamps
A.
Turn Signal-Taillamp
B. Stop-Taillamp
C.
Back-up Lamp
D.
Sidemarker Lamp
x
5-61
To Next Page
Loading...
