1.
Use a screwdriver
to
remove the two screws
from the lamp
assembly.
2.
Remove the lamp assembly.
3.
Press the release tab and turn the bulb socket
counterclockwise
to
remove
it
from the taillamp
housing. (The sidemarker lamp does not have a
release
tab.)
5.
6.
Press a new bulb into the socket, insert it into the
taillamp housing and turn the socket clockwise into
the taillamp housing until it clicks. The sidemarker
lamp does not have a release tab and therefore will
not click when it is installed.
Reinstall the rear lamp assembly and tighten the
screws.
5-62
To Next Page
Loading...
