MEMORY POSITIONS FOR
DRIVER’S SEAT, MIRRORS,
PEDALS, RADIO AND CLIMATE
CONTROLS
Use the
driver’s
door
mounted
controls
to:
• Adjust
driver seat, including lumbar
adjustment and side bolster
• Adjust gas and brake pedals
• Adjust the outside rearview
mirrors
• Set the
radio
presets and
• Set climate
control
temperature
1 To store the
above settings, press and hold
Memory 1 or 2 until two chimes
sound (about four seconds). To set
up for another driver, repeat the
process with the other memory
button.
These settings can be restored by
pressing the Memory 1 or 2 button
on the driver’s door or by using the
Remote Keyless Entry (RKE)
transmitter.
The vehicle memory
settings will correspond to the
number on the RKE: 1 or 2.
Set Easy Exit Driver Seat Position
1. Briefly press memory button 1 or
2 (depending on which RKE you
have).
2. Adjust the seat to the desired exit
position.
3. Press and hold the exit button
( ) on the driver’s door until
two chimes sound. (Note: Seat
Exit must be “On” in your
programmed settings.)
DRIVER INFORMATION CENTER
PERSONALIZATION
You can personalize your vehicle with
the following features:
• Automatic Locking
• Delayed Locking
• Automatic Unlocking
• Remote Lock Feedback
• Remote/Unlock Feedback
•Headlamps On at Exit
• Perimeter Lighting
• Seat Position Recall
• Easy Exit Driver Seat
• Curb View Assist
• Alarm Warning Type
• Display Language
• Display Units
ESCALADE/ESCALADE ESV
Vehicle Personalization
Note: Memory 1 or 2 is dependent on the
RKE transmitter being used and the key
being in the ignition during programming.
1
To Next Page
Loading...
