Navigation delete destination, navigation cancel
destination: These commands instruct the system to
cancel the current destination. The system will
request that you confirm. After the prompt, state “Yes”
to confirm or “No” to cancel.
Navigation delete all waypoints and destination,
navigation cancel all waypoints and
destination: These commands instruct the system to
cancel the current destination and all waypoints.
The system will request that you confirm. After the
prompt, state “Yes” to confirm or “No” to cancel.
Navigation voice guidance off, navigation voice
guidance: These commands instruct the system to turn
route voice guidance off and on.
Navigation detour [entire route]: This command
instructs the system to add a detour to your route.
The system will request that you confirm. After
the prompt, state “Yes” to confirm or “No” to cancel.
Radio Commands
The following are radio commands you can access by
clearly stating the commands exactly as they are written.
The commands are only available when you are in
one of the following audio modes, AM, FM, XM™
(if equipped), or WX (if equipped).
Radio, radio turn off: These commands instruct the
system to turn the audio system on and off.
Radio [set] balance center, radio [set] balance
middle, radio [set] fade center, radio [set] fade
middle: These commands instruct the system to set
the fade or balance to the center and middle.
Radio scan up, radio scan down: These commands
instruct the system to scan up or down through radio
stations.
Radio [band] [select] AM, radio [band] [select] FM,
radio [band] [select] XM, radio [band] [select]
satellite, radio [band] [select] WX, radio [band]
[select] weather band: These commands instruct the
system to go to either the AM, FM, XM (if equipped),
or WX (if equipped) radio bands.
Radio [select] (frequency) AM, radio [select]
(frequency) FM, radio [select] (channel) weather
band: These commands instruct the system to go to a
specific frequency on either the AM, FM, weather bands.
Radio [select] (channel) XM, radio [select] (channel)
satellite: These commands instruct the system to
go to a specific channel on the XM™ band (if equipped).
Radio [show] [next] presets: This command instructs
the system to change to the next presets on the
active band.
Radio help: This command instructs the system to
assist with radio commands. The radio commands will
be displayed on the screen.
4-12
To Next Page
Loading...
