Turn Signal/Multifunction Lever
The lever on the left side of the steering column
includes the following:
• G Turn and Lane-Change Signals. See Turn
and Lane-Change Signals on page 3-9.
• O Headlamps. See Headlamps on page 3-16.
• 3 Headlamp High/Low Beam-Changer. See
Headlamp High/Low-Beam Changer on page 3-10.
• Flash-To-Pass Feature. See Flash-to-Pass
on page 3-10.
• - Fog Lamps. See Fog Lamps on page 3-19.
• I Cruise Control. See Cruise Control on
page 3-13.
Turn and Lane-Change Signals
To signal a turn, move the lever all the way up or
down. The lever returns automatically when the turn
is complete.
An arrow on the instrument
panel cluster will flash in
the direction of the
turn or lane change.
Raise or lower the lever until the arrow starts to flash
to signal a lane change. Hold it there until the lane
change is complete. The lever returns to its original
position when it is released.
Rapid flashing of arrows when signaling for a turn or
lane change may be caused by a burned-out signal bulb.
Other driver’s will not see the signal.
Replace burned-out bulbs to help avoid possible
accidents. Check the fuse and for burned-out bulbs
if the arrow fails to work when signaling a turn.
See Fuses and Circuit Breakers on page 5-104 for
more information.
3-9
To Next Page
Loading...
