4. Lift the wiper blade assembly up so it is in a
T-shaped position. You should be able to see a tab.
5. Squeeze the tab together and pull the wiper blade
assembly down far enough to release it from the
J-hooked end of the wiper arm. Slide the assembly
away from the arm.
Allowing the wiper blade arm to touch the windshield
when no wiper blade is installed could damage
the windshield. Any damage that occurs would
not be covered by your warranty. Do not allow
the wiper blade arm to touch the windshield.
6. Replace the blade with a new one.
7. Reinstall the wiper blade assembly by sliding it
over the wiper arm to engage the J-hooked end.
Pull up on the assembly to lock it into place.
8. Repeat the steps for the other wiper.
5-56
To Next Page
Loading...
