Voice Recognition
The navigation system’s voice recognition allows for
hands-free operation of navigation, audio system, and
OnStar
®
features. Voice recognition can be used
when the ignition is on or when Retained Accessory
Power (RAP) is active. See “Retained Accessory Power
(RAP)” in the Index of your vehicle’s owner manual
for more information.
To use voice recognition, do the following:
1. Press the talk symbol
steering wheel control
and release it when
you hear a beep. The
audio system, if on,
will mute.
2. Clearly state one of the commands listed on the
following pages.
Helpful Hints for Stating Commands
•
When a multiple command is available, choose the
command that best works for you.
• Words that are in brackets are optional. For
example, for the command Radio [band] [select] FM,
stating Radio FM or Radio select FM are both
valid commands.
• When the system recognizes the command the
system will:
• either perform the function
• ask you to confirm your choice by clearly stating
“yes or no”
• issue an error message such as “System does
not recognize this command” or direct you to
“Please start speaking after the beep”
• If the system is not yet ready, the system may state
“System is checking the disc. Please wait”.
• To cancel a command or if the system response
does not match your verbal command, press
and hold the talk symbol button. The system will
reply, “System will cancel the voice recognition”.
4-2
To Next Page
Loading...
