Removing the 50/50 Split Bench
Seat(s)
To remove the seat, do the following:
1. Open the liftgate to access the controls for the
50/50 seat(s) and enter the rear of the vehicle.
2. Fold the seatback forward using the instructions
listed under “Folding the Seatbacks” previously.
The seat cannot be removed unless the seatback
is folded.
3. Unlatch the rear of the
seat from the floor by
pulling up on the
release lever labeled 2,
located next to the
carrying handle at the
rear of the seat.
4. Lift the rear of the seat up from the floor.
5. Squeeze the release lever to release the seat from
the floor, while pulling the seat out.
6. While holding the rear of the seat up, roll the seat
out of the vehicle.
1-17
To Next Page
Loading...
