Cadillac 2006 STS - Setting the Time; Setting Radio Station Presets

Setting Radio Station Presets
To set preset radio stations, do the following:
1. Press the power/volume knob to turn the system on.
2. Press the BAND hard key.
3. Select the desired band (AM, FM1, FM2, XM1, or
XM2 (if equipped)).
4. Seek, scan, or tune to the desired stations using
the seek and scan hard key arrows or the
tuning knob.
5. Press and hold one of the six preset screen buttons,
at the bottom of the screen, until you hear a beep or
see the station displayed on the selected preset
button.
6. Repeat the steps for each preset.
See “Preset Stations” under Navigation Audio System
on page 3-2 for more information.
Setting the Time
To set the time, do the following:
1. Press the power/volume knob to turn the system on.
2. Press the CONFIG hard key.
3. Press the
H (clock) screen button.
4. Select the 12hour or 24hour screen button to
display the time in standard or military time.
5. Select the AM or PM screen buttons.
6. Select the appropriate time zone screen button.
7. Select the Daylight Saving Time screen button,
if necessary.
8. Press and hold the hour and minute arrow buttons to
increase or to decrease the time or press the GPS
TIME screen button to reset radio time to GPS time.
The radio will use the GPS satellite to set the time. The
vehicle needs to be in an open area to receive the signal.
See “Clock” under Configure Menu on page 2-52 for
more information.
1-7