Cargo Management System
Your vehicle may be equipped with a cargo
management system. It can be used for storing
and separating cargo and as a table. The
maximum load is 200 lbs. (91 kg) distributed.
It is located in the rear of the vehicle on upper or
lower horizontal guides. There are two vertical
curved guides that connect the upper and
lower horizontal guides together. The system has
three rollers on each side. The system will be
equipped with either a release lever, located in
the middle handle, or a tab located on the
side. These engage and disengage a locator pin.
These are used in adjusting and positioning
the system.
The cargo management system can be positioned
on the upper or lower horizontal guides.
To adjust the system from the upper guide to the
lower guide, do the following:
1. Squeeze and hold the release lever, or slide
the tab towards the inside of the vehicle,
to retract the locator pin.
2. Pull the system back until the front rollers
reach the vertical curved guides.
176
To Next Page
Loading...
