Service and Maintenance
. . . 454
License Lights
1. Push the tab to remove the
license plate light.
2. Rotate the light assembly
down and remove it.
3. Turn the socket counterclock-
wise and remove it.
4. Remove and replace the bulb.
Pull the bulb straight out of the
socket.
5. When reinstalling the bulb
socket, align the tabs on the
socket with the tabs in the
light assembly, then slide it in.
Turn the bulb socket clockwise
to secure.
6. Reinstall the lamp assembly.
Align the two nubs on the
outboard edge of the light
assembly housing with the
outboard flange of the vehicle
opening.
7. Rotate the inboard side of
light assembly upward and
snap the assembly into place.
AKENG40_CTS Page 454 Wednesday, July 23, 2008 11:47 AM
To Next Page
Loading...
