Cadillac 2008 CTS - Page 485

485 . . .
–
–
–
–
–
Section 5
NOTICE
If you try to raise the vehicle
with the jack positioned under
the rocker molding, the
molding could break and the
vehicle could be damaged.
Position the jack so that the jack
head will rise to the notch
(inboard of the rocker molding)
in the vehicle's frame.
4. Attach the wheel wrench to
the jack.
Insert the hook end of the
extension handle into the jack.
Insert the flat end of the
extension handle through the
wheel wrench.
5. Make sure the spare tire is
near the flat tire.
6. Position and raise the jack so
that the slots in the jack head
fit into the metal flange
located behind the arrow on
the plastic molding.
Turn the wheel wrench
clockwise to raise the jack.
7. Raise the jack until the jack
head fits firmly into the notch.
Then raise the vehicle off the
ground until there is room for
the spare tire to fit.
AKENG40_CTS Page 485 Wednesday, July 23, 2008 11:47 AM