Cadillac 2008 CTS - Page 499

499 . . .
–
–
–
–
–
Section 5
13. Press I (on) or the on/off
button to turn the system on.
The compressor will force
sealant and air into the tire.
Tire sealant may leak from the
puncture hole until the vehicle
is driven and the hole has been
sealed.
Initially, the pressure gage
reading will be high while the
air compressor pushes the
sealant into the tire. When the
tire begins inflating with air,
the pressure reading will drop
quickly, and then rise again as
the tire inflates.
14. Use the air compressor to
inflate the tire to the proper
inflation pressure as shown
on the Tire and Loading
Information Label.
See "Tire and Loading
Information Label" in Section 3
for more information.
15. Check the tire pressure using
the air pressure gage on the
tire sealant and compressor
kit.
NOTE:
The pressure gage reading is
slightly higher while the air
compressor is on. Turn the
compressor off to get an
accurate pressure reading.
NOTICE
If the proper tire pressure
cannot be reached after
25 minutes, the vehicle should
not be driven. Damage to the
tire is severe and the tire cannot
be inflated or sealed using the
tire sealant and compressor kit.
CAUTION
Be careful not to overinflate
things. They could explode and
you or others could be injured.
Be sure to follow any
instructions that come with the
tire sealant and compressor kit.
Inflate the tire to its
recommended pressure.
Do not exceed the
recommended pressure.
AKENG40_CTS Page 499 Wednesday, July 23, 2008 11:47 AM