Removing the Flat Tire and
Installing the Spare Tire
1. Do a safety check before proceeding. See Changing
a Flat Tire on page 5-96 for more information.
2. Loosen all of the wheel nuts, but do not remove
them yet, using the wheel wrench. Turn the
handle about 180 degrees, then flip the handle
back to the starting position. This avoids taking the
wrench off the lug nut for each turn.
3. Find the vehicle’s jacking location using the
diagram above and corresponding V–shaped
notches located in the plastic molding on the
vehicle’s frame. The notches in the plastic molding
are marked with a triangle shape.
5-99
To Next Page
Loading...
