If something has blocked the driver seat or the steering
column while recalling a memory position, the recall may
stop. Remove the obstruction, then press the appropriate
control for the area that is not recalling for two seconds.
Try recalling the memory position again by pressing the
appropriate memory button. If the memory position is
still not recalling, see your dealer/retailer for service.
Easy Exit Recall
S
: With the vehicle in P (Park) for an automatic
transmission or the parking brake applied for a manual
transmission, press the exit button to recall the exit
position.
If the easy exit seat feature is on in the DIC, automatic
seat and power telescopic steering column movement
occurs when the key is removed from the ignition.
On vehicles with the Keyless Access System, automatic
adjustment occurs when the ignition is turned to OFF
and the driver door is opened.
A single beep sounds. The driver seat moves back, and
if the vehicle has the power tilt wheel and telescopic
steering feature, it moves up and forward.
See “EASY EXIT RECALL” under DIC Vehicle
Customization on page 3-71 for more information.
For more programming information, see DIC Vehicle
Customization on page 3-71.
1-9
To Next Page
Loading...
