Voice recognition can be used when the ignition is on or
when Retained Accessory Power (RAP) is active. See
“Retained Accessory Power (RAP)” in the Index of
your vehicle’s owner manual for more information.
To use voice recognition, do the following:
1. Push and hold the
SRCE button on the
steering wheel until you
hear a beep. The
audio system mutes.
2. Clearly state one of the commands listed on the
following pages.
Helpful Hints for Stating Commands
•
When a multiple command is available, choose the
command that works best.
• Words that are in brackets are optional. For
example, for the command Radio [band] [select] FM,
stating Radio FM or Radio select FM are both
valid commands.
• When the system recognizes the command the
system does one of the following:
− Perform the function.
− Ask you to confirm your choice.
− Issue an error message “Did not recognize.
Voice Recognition Canceled.”
• If you experience difficulty with the system
recognizing a command, try saying it more softly,
and wait for a few seconds after the beep, or repeat
the command.
• Background noise may cause voice commands
to be misunderstood, including airflow noise
from wind.
• To use the voice recognition system, the map
DVD must be loaded and the navigation system
must be on.
4-79
To Next Page
Loading...
