Every fifty times the vehicle is started and the navigation
system is turned on, the Warning screen appears.
After reading the warning, select OK to load the map
DVD information. If OK is not selected, all hard
keys except for NAV (Navigation) and DEST
(Destination) can be accessed. You can also press the
NAV hard key to have this Warning screen appear.
When getting started, set the navigation system to
your preference or delete information you may have
entered using various options.
Deleting Personal Information
This navigation system can record and store
destinations. At times, such as the disposal of your
vehicle, you may want to delete these destinations.
Refer to the following sections to delete the destination
information that has been stored.
See “Memory Points” under Navigation Menu on
page 2-18 for deleting stored destinations.
Storing Radio Station Presets
To set preset radio stations:
1. Press the power/volume knob to turn the system on.
2. Press the BAND hard key.
3. Select the desired band (AM, FM1, FM2, XM1, or
XM2 (if equipped)).
4. Seek, scan, or tune to the desired stations
using the seek and scan hard key arrows or
the tuning knob.
5. Press and hold one of the six preset screen
buttons, at the bottom of the screen, until a beep is
heard or see the station displayed on the selected
preset button.
6. Repeat the steps for each preset.
See “Preset Stations” under Navigation Audio System
on page 3-2 for more information.
1-7
To Next Page
Loading...
