Voice Recognition Commands
The following list shows all of the voice commands
available for the navigation system with a brief
description of each. The commands are listed with the
optional words in brackets. To use the voice commands,
refer to the instructions listed previously.
Display Commands
Display [set] English units: Instructs the system to
switch to English units of measurement. All display
settings change.
Display [set] metric units: Instructs the system to
switch to metric units of measurement. All display
settings change.
Display [set] day mode: Instructs the system to
switch the system display to day mode. See “Screen
Appearance” under Configure Menu on page 2-59
for more information.
Display [set] night mode: Instructs the system to
switch the system display to night mode. See “Screen
Appearance” under Configure Menu on page 2-59
for more information.
Display [set] auto mode: Instructs the system to
switch the system display to auto mode. See “Screen
Appearance” under Configure Menu on page 2-59
for more information.
Display Help: Instructs the system to offer
assistance with the previously listed display commands.
The Navigation System displays the commands on
the screen.
General Navigation Commands
Navigation [show] current position, navigation
[show] current location: Instructs the system to show
the vehicle’s current position on the map.
Navigation [show] map: Instructs the system to show
the current map screen.
Navigation [command] help, navigation [command]
list: Instructs the system to state the navigation
command help list.
Navigation repeat [voice] [guidance]: Instructs the
system to repeat the previous voice guidance prompt.
Cancel: This command instructs the system to
cancel the most recently given command.
4-5
To Next Page
Loading...
