Map Commands
Navigation zoom in, navigation zoom out: Instructs
the system to zoom in or out on the map.
Navigation [change] map direction: Instructs the
system to change the direction of the map to heading
up/north up depending on previous setting.
Navigation store [this point], navigation mark
[this point]: Instructs the system to store or mark a
point in its memory. These commands are available
while a map screen is displayed.
Navigation [change to] 3-D map [mode], navigation
[change to] 2-D map [mode]: Instructs the system
to switch between 2-D and 3-D map modes. These
commands are available while a map screen is
displayed.
Point of Interest (POI) Commands
The following is a list of POI commands. State the
commands exactly as they are written to receive
information from the system regarding that specific
command. POIs only displays on the map screen if the
map scale is
1
⁄
2
mile (1 km) or less. If POIs are
displayed on a map with the wrong scale, the system
indicates this. When you are ready to exit the POI
command mode, state “POI off”. The available POI
commands are:
Automobile Commands
• Navigation Automobile Club
• Navigation Triple A
• Navigation Car Wash
• Navigation Gas Station
• Navigation Gas
• Navigation Parking
• Navigation Parking Lot
• Navigation Parking Garage
• Navigation Car Park
• Navigation Auto Service and Maintenance
4-6
To Next Page
Loading...
