Reinstalling the Cargo Cover Panels
The strap system can remain attached to the side of the
cargo area while it is not in use, or it can be stored
inside the top box storage compartment. See Top-Box
Storage
on page 3‑76
for more information.
To reinstall a cargo panel:
1. Starting with cargo panel 1, place the latches in
the unlocked position. Place cargo panel 1 on the
cargo area rails while holding the back of the cargo
panel up.
Driver Side Shown, Passenger Side Similar
Place the cover on the cargo box within 4 inches of
the Midgate
®
and lower the rear of the panel within
2 to 3 inches from the top of the cargo box. Push
the cover forward making sure that the guide block
engages the retainer bracket opening. Continue to
push forward until the panel is fully seated against
the Midgate. Then lower the rear of the cover to
engage the striker pegs (A) to align with the striker
assembly (B).
3-68
Ofrecido por www.electromanuales.com
To Next Page
Loading...
