.
The headlamp stalk is moved forward to the
high-beam position. See Headlamp High/
Low-Beam Changer
on page 4‑5
.
When either of these conditions occur, the
IntelliBeam
®
feature will be disabled and the
IntelliBeam
®
light in the mirror will turn off until the
high-beam stalk is returned to the neutral position.
.
If IntelliBeam
®
was using low-beams prior to this
action, the IntelliBeam
®
feature will be temporarily
disabled until the stalk is returned to the neutral
position.
.
The exterior lamp control is turned to any setting
except AUTO.
When this occurs, IntelliBeam
®
will be disabled
until the control is turned back to the AUTO
position.
.
The IntelliBeam
®
system is turned off at the inside
rearview mirror.
IntelliBeam
®
may not turn off the high-beams if the
system cannot detect other vehicle's lamps because of
any of the following:
.
The others vehicle's lamp(s) are missing,
damaged, obstructed from view or otherwise
undetected.
.
The other vehicle's lamp(s) are covered with dirt,
snow and/or road spray.
.
The other vehicle's lamp(s) cannot be detected
due to dense exhaust, smoke, fog, snow, road
spray, mist or other airborne obstructions.
.
Your vehicle's windshield is dirty, cracked or
obstructed by something that blocks the view of
the IntelliBeam light sensor.
.
Your vehicle's windshield is covered with ice, dirt,
haze or other obstructions.
.
Your vehicle is loaded such that the front end of
the vehicle points upward, causing the IntelliBeam
sensor to aim high and not detect headlamps and
taillamps.
.
You are driving on winding or hilly roads.
You may need to manually disable or cancel the
high-beam headlamps by turning the low-beam
headlamps on, if any of the above conditions exist.
4-13
To Next Page
Loading...
