Power Lumbar
The controls are on the
outboard side of the front
seats.
Press the front or rear of the lumbar control to increase
or decrease support. Press the top or bottom of the
control to raise or lower the support mechanism.
Massaging Lumbar
If available, the switch is
on the outboard side of
the front seats.
Press the switch to turn the massaging lumbar feature
on. To operate, the ignition must be on. The massage
cycle will run for up to 10 minutes. To stop the massage,
press the switch again or press the power lumbar
switch.
2-4
To Next Page
Loading...
