Driving and Operating 9-35
TCS/StabiliTrak Light
When the stability control system
activates,
d flashes on the
instrument cluster. This also occurs
when traction control is activated.
A noise may be heard or vibration
may be felt in the brake pedal. This
is normal. Continue to steer the
vehicle in the intended direction.
If there is a problem detected with
StabiliTrak, a message is displayed
on the Driver Information Center
(DIC). See Ride Control System
Messages on page 5‑38. When one
of these messages is displayed and/
or
d comes on and stays on, the
vehicle is safe to drive but the
system is not operational. Driving
should be adjusted accordingly.
If
d comes on and stays on, reset
the system:
1. Stop the vehicle.
2. Turn the engine off and wait
15 seconds.
3. Start the engine.
If
d still comes on and stays on at a
speed above 20 km/h (13 mph), see
your dealer for service.
Manual Transmission TCS/
StabiliTrak Button Shown,
Automatic Transmission TCS/
StabiliTrak Button Similar
StabiliTrak Off
Light
TCS Off Light
StabiliTrak and traction control can
be turned off if needed by pressing
and holding
g until g and i come
To Next Page
Loading...
